Re: Some 2.6.3 results - but still gscanbus not working completely right

On 11 Mar, Mark Knecht wrote:
> Error while reading from IEEE1394: : Resource temporarily unavailable
> Could not read topologyMap
> Error while reading from IEEE1394: : Resource temporarily unavailable
>
> gscanbus creates a window with nothing in it. I unplugged the CDWR, the
> gscanbus window now shows the topology,

Gscanbus reads the topology map from the local node. The map
contains the self id info and gscanbus builts its internal and
finally its graphical representation of the network from it. If
the local node was unable to obtain proper self id info, gscanbus
cannot draw the bus.

(BTW gscanbus does not display subtrees below nodes that have
more than 3 child nodes attached. It also prints some irritating
error messages if a repeater without config rom is attached, but
that is perfectly normal.)

> All three devices are standard off the shelf components mounts in ADS
> Pyro drive kits. The CDRW and DVD are in identical models with two 1394
> ports.

The fact that one of them behaves so much different is certainly
confusing.

-- 
Stefan Richter
-=====-=-=-- --== -=-==
http://arcgraph.de/sr/
-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click
_______________________________________________
mailing list Linux1394-user@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/linux1394-user